Requirements:
Model: TX-7471
Firmware version: 10.8.0.0
If you have a 7471 and it is not on version 10.8.0.0, please use the steps here to update the transmitter first before reprogramming the pagers.
Model: TX-7470
Firmware version:
To Enable Group Paging on TX-7471 and TX-7470: (Groups has to be enabled before the pagers will accept programming for groups)
- Press the SETUP button
- Enter 31337 for the password
- Press 1 for System
- Press F2 two times
- Press 1 for POCSAG
- Press F2 one time
- Press 2 for Group Paging
- Press 1 for Groups Enabled
- Press F1 for YES
To Program E467s & Groups:
- Press the SETUP button, enter 31337
- Press F2 one time
- Press 1 for Program
- Press 1 for Prg Pager
- Press 2 for Staff Pager
- Press 2 for LRS Alpha
- Enter the pager # you want the pager to be and press ENTER one time (This will be a 3 digit number / usually the number on the pager).
- Enter and group #s you want (up to five groups) and press F3 one time when finished or up to 5 groups are entered in.
8A - This is how to Enter groups – you are on the screen asking for a group number. You have to type in the group numbers (if more than 1), one at a time. Type in the group number and press enter. The number will disappear and it will stay on that screen. If adding another group, type in that number and press enter. When done adding up to 5 groups, press the F3 button to get onto the next screen.
- The Transmitter screen will now say: “Reset the pager….“ At this step, Remove and then re-insert the battery in the E467 pager, Hold it in with your fingers, look at the screen and you will see C1: C2: C3 listed on the pager screen. At this moment, Press the ENTER Button on the transmitter one time
- You should start to hear beeps from the pager as it is getting programmed. When finished, confirm you heard the correct # of beeps from the pager and press either F1 to program another pager or press F4 until you are back at the home screen