Follow

Charging issues with Table Tracker units / Specific Table Tracker Units that do not read

  • Each base can stack 10-15 units using a DC power supply only
  • Charging bases should not be daisy-chained together using jumper cables (regardless of setup)
  • Yellow LRS light should be pulsing/glowing on each unit
  • Light at base of each unit should turn green when placed on Starter/Clearer – failure to do so may indicate that the unit may not be charging properly
  • If the Table Tracker Unit LED does not turn green or red when placed on the Starting Unit, it will need to come in for repair or be replaced
  • Ensure that the power supply connected to each Charging Base is 12V DC
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk