Follow

How do I program my pagers?

The pagers are shipped already programmed. If you would like to renumber the pagers or program the pagers into groups, follow the steps below:

  1. Connect the Butler XP to your computer using the mini USB cable.
  2. Open the Butler configuration utility.
  3. Click on Tools>Program Pagers
  4. Select the primary pager number to be programmed into the pager as well as any groups.
  5. Remove the battery from the pager and then re-inset it into the pager.
  6. Click on 'Program'.
  7. The pager should respond with a series of beeps.
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk