Follow

Steps to Reset the LRS TX-9560MT Transmitter

If your LRS TX-9560MT Transmitter is not having a power issue and you have verified that it is charging but will not page your pagers, here are steps to reset this transmitter to page the pager type that is in use at your location.

Please use these quick steps to reset the transmitter and then test page:

STEPS TO SETUP PAGING GUEST PAGERS (Guest paging is the default paging mode for this transmitter)

  1. Hold down the reset button on the right side of the transmitter for 3 seconds
  2. Type in PROG-0-0-0 Ent (This fully resets the device)
  3. Press 9-9-6-PROG for Guest Paging Mode 
  4. Press 9-0-X-PROG to Set the System ID for your location (your System ID=X)

(Note: If you do not know the System ID for your location, please contact LRS.)

 

STEPS TO SETUP PAGING STAFF PAGERS

  1. Hold down the reset button on the right side of the transmitter for 3 seconds
  2. Type in PROG-0-0-0 Ent (This fully resets the device)
  3. Press 9-9-9-PROG for Guest Paging Mode 
  4. Press 9-0-X-PROG to Set the System ID for your location (your System ID=X)

(Note: If you do not know the System ID for your location, please contact LRS.)

Once you have followed these steps, remove a pager from the charging base and attempt to page it. If the pager pages, please keep these steps should this issue occur again (the transmitter may have been reset on accident by someone else at the location).

If these steps do not resolve the issue that you are having, please contact LRS Customer Support by submitting a ticket to support@lrsus.com and we will assist you to troubleshoot further.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk