Program CS7 Coaster Pagers with the T-7471 Transmitter
Have all pagers on the charger to start. Only program those that need it. Keep the pagers you wish to reprogram at the top of the stack so they are easy to get to. If possible, have all the pagers on other charging stacks so you have 1 charger that is empty and an easy place to put finished pagers.
When a pager is done programming, it has responded with a single flash and the number on the display has changed, please put it back on the charger so it will won't receive a program it should not have when you do the next one.
press the Setup button on the transmitter
Type in code 5, 6, 7, 8, 9
Press #1 for program
Choose option 1 for program pager
Select 1 for guest
Select 1 for coaster
Select 1 for non-alpha
F1 for Vibe On
type in pager # you want the pager to be. (if the pager is 1, just type in 1 - no additional zeros)
take the pager off the charger
allow initial wake up to take place
when it stops, press the enter key 1 time.
The pager should flash 1 time to show it accepted the programming and the number will reflect the pager number you wanted it to be.
go through the prompts to finish or program another pager
When a pager is done programming, it has responded with a single flash and the number on the display has changed, please put it back on the charger so it will not get a program it should not have when you do the next one.
if lost in the menu, just have all the pagers on charger and you can press any key needed to get back to where you want to be, or just pull the power from the back, wait 5 seconds and plug it back in.